BOSCH 800 SERIES DISHWASHER Series Leaving White Film
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Detergent and Rinse Aid Dispenser Assembly
The dispenser utilizes a wax motor or solenoid to actuate the rinse aid door during the final high-temperature rinse. If this component fails to deploy rinse aid, water cannot sheet off the dishes, leading to mineral and surfactant deposition during the condensation drying process. Replacing the entire assembly ensures the door latch and fluid delivery mechanism are synchronized.
SKU: 00645027
|
|
|
7%
CONF
|
Water Softener Salt Reservoir Cap
The Bosch 800 contains an ion-exchange water softener. If the cap gasket is deformed or the cap is cracked, concentrated brine leaks into the wash tub during active cycles rather than staying confined to the regeneration phase, leaving a thick, white, salty film on all surfaces.
SKU: 00611319
|
|
|
7%
CONF
|
Water Inlet Valve
Insufficient water levels caused by a restricted inlet valve prevent the dishwasher from performing a thorough 'purge' rinse. This results in high concentrations of suspended food particles and detergent chemicals remaining in the final rinse water, which then dry onto the dishes as a cloudy film.
SKU: 00628334
|
DIY Repair Guide
Watch exactly how to replace the Detergent and Rinse Aid Dispenser Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.