WHIRLPOOL WASHER WTW7120 Leaking From Bottom
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Drain Pump Assembly
The drain pump's internal mechanical seal often fails due to friction or small debris bypassing the filter. This results in water escaping through the pump housing or motor shaft, dripping directly onto the floor from the bottom of the cabinet. It is the most common source of non-centralized puddling under this model.
|
|
|
8%
CONF
|
Tub Seal
Located at the base of the drive shaft, this seal prevents water from exiting the outer tub. If compromised by detergent buildup or wear, water will leak down the center of the drive assembly, often leaving a tell-tale spray pattern or rust on the rotor and stator components.
SKU: W10324647
|
|
|
6%
CONF
|
Water Inlet Valve
This model features a built-in faucet and high-pressure fill. Hairline cracks in the valve body or a loose internal connection to the Load & Go dispenser can cause water to track down the inner rear cabinet wall, pooling at the bottom and mimicking a tub leak.
|
DIY Repair Guide
Watch exactly how to replace the Drain Pump Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.