WHIRLPOOL WTW7120HC Door Locked Error
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
85%
CONF
|
Lid Lock Assembly
This assembly contains both the actuator solenoid and the sensing circuit. Electrical failure in the solenoid or mechanical fatigue in the return spring prevents the latch from fully engaging the lid strike. Without a confirmed continuity signal from the internal microswitch, the control board terminates the cycle for safety.
SKU: W11451556
|
|
|
10%
CONF
|
Lid Strike
The lid strike is the physical interface that the lock bolt slides into. If this plastic component is chipped, bent, or misaligned, the lock bolt cannot reach its full extension. This prevents the internal sensing switch from closing, leading to a persistent 'locked' error even if the solenoid is firing.
SKU: W10837741
|
|
|
5%
CONF
|
Main Electronic Control Board
The main control board manages the timing and power delivery for the lid lock solenoid. If the onboard relay or triac responsible for the lock circuit fails, no power is sent to the latch mechanism. This is considered a last-resort failure mode when the latch and strike are verified to be mechanically sound.
SKU: W11613143
|
DIY Repair Guide
Watch exactly how to replace the Lid Lock Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.