SAMSUNG WASHER WF45R6100 Door Locked Error
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
Door Lock Switch Assembly
This assembly contains the solenoid and sensing switch that signals the PCB that the door is safely secured. Over time, the internal contacts corrode or the locking solenoid fails, preventing the cycle from starting and triggering the 'Door Locked' error. Replacing this component restores the electrical feedback loop required for the washer to initiate high-speed spin and wash functions.
SKU: DC34-00025A
|
|
|
4%
CONF
|
Door Striker
The striker is the plastic 'hook' on the door that physically engages the lock assembly. If this part is cracked, misaligned, or worn down, it will not fully actuate the mechanical switch inside the lock assembly even if the door is closed. This results in the system failing to register a 'locked' state, leading to the error code.
|
|
|
3%
CONF
|
Main Control Board
The main PCB contains the triacs and relays that send voltage to the door lock solenoid. If the door lock and striker are physically intact but the error persists, the control board may have a failed circuit that is unable to send the locking signal or process the return signal from the latch. This is considered the final resolution step if the latch replacement does not clear the error.
SKU: DC92-02454A
|
DIY Repair Guide
Watch exactly how to replace the Door Lock Switch Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.