MAYTAG WASHER MVW6200KW Not Draining
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
Drain Pump Motor Assembly
The drain pump is responsible for physically removing water; however, in this model line, the internal motor windings often fail or the connection terminals become corroded due to their position. If the pump shows no resistance (infinity) when tested with a multimeter, the motor is burnt out and must be replaced to restore the drainage cycle.
|
|
|
4%
CONF
|
Washing Machine Wiring Harness
Expert field data indicates the harness frequently abrades where it connects to the drain pump under the tub. This 'pattern failure' creates a broken circuit or short-to-ground that stops the pump from receiving power. Replacing the harness or the specific sub-segment leading to the pump is the only permanent fix for recurrent drainage issues on this model.
|
|
|
3%
CONF
|
Pressure Sensor Hose
If the pressure hose is pinched, kinked, or clogged with sediment, the control board will not detect that the water level is high or will incorrectly believe the tub is still full/empty, preventing the drain pump from engaging. This is a common secondary cause if the pump and wiring are found to be electrically sound.
SKU: W11424905
|
DIY Repair Guide
Watch exactly how to replace the Drain Pump Motor Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.