ECHO TRIMMER SRM 225 String Won T Feed
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
Speed-Feed 400 Trimmer Head
The SRM-225 is factory-equipped with a Speed-Feed head which utilizes an internal cam-and-carrier system to advance line. Over time, dirt ingress and friction wear down the plastic indexing tabs and eyelets, causing the mechanism to bind. Replacing the entire assembly is the most reliable fix for a 'won't feed' symptom as it eliminates mechanical wear and potential assembly errors with the internal disk.
SKU: 99944200907
|
|
|
4%
CONF
|
Inner Disk Carrier (Spinner)
This specific component has directional markings ('L' for Left and 'R' for Right). If installed with the 'L' facing the gearcase, the cam action is inverted, causing the trimmer to tighten the line during a bump instead of releasing it. This part is the most common specific sub-component to be either damaged or installed incorrectly by the user during re-spooling.
|
|
|
3%
CONF
|
Trimmer Head Eyelets
The metal eyelets where the string exits the head often develop deep grooves or 'notches' from the friction of the nylon line. These notches create high physical resistance that prevents the line from sliding through the exit port during a bump cycle, effectively locking the line inside the head despite the internal mechanism functioning correctly.
SKU: X475000050
|
DIY Repair Guide
Watch exactly how to replace the Speed-Feed 400 Trimmer Head.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.