CREALITY K1 MAX Error Code Key 2564
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
Ceramic Heating Block Kit
This kit includes the 60W ceramic heating ring and the NTC thermistor. Error 2564 is triggered when the MCU detects a discrepancy between the power sent to the heater and the temperature reported by the thermistor. Replacing the integrated assembly ensures a proper thermal bond and eliminates the possibility of wire fatigue at the connector junction.
SKU: 4001030111
|
|
|
4%
CONF
|
NTC Thermistor Sensor
The thermistor is the primary feedback component; if it fails open or provides erratic resistance values due to internal degradation or a loose set screw, the printer will halt for safety. This part specifically resolves the feedback failure if the heater cartridge itself remains functional.
|
|
|
3%
CONF
|
Complete Hotend Assembly
In cases where the error persists due to heat creep or structural damage to the heat break affecting thermal conductivity, the entire hotend assembly provides a comprehensive fix. This ensures all components, including the nozzle and heat break, are aligned to factory specifications for proper heat dissipation.
SKU: 4001030070
|
DIY Repair Guide
Watch exactly how to replace the Ceramic Heating Block Kit.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.