SAMSUNG WA45T3400 Wont Spin Le Error
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Water Level Pressure Sensor
The pressure sensor (transducer) monitors water levels by converting pneumatic pressure into an electrical frequency. If the internal diaphragm fails or the electronic signal drifts, the control board receives an 'out of range' signal that mimics a sudden water loss (leak). Replacing this sensor restores the machine's ability to accurately detect tub volume and clears the safety lockout preventing the spin cycle.
SKU: DC96-01703G
|
VIEW ON AMAZON
#CommissionsEarned
|
|
5%
CONF
|
Pressure Sensor Air Tube
A pinhole leak or crack in the vinyl air tube causes a loss of hydrostatic pressure before it reaches the sensor. This drop in pressure during the cycle is interpreted by the firmware as water leaking out of the tub, triggering the LE error code. This part is critical for maintaining the pneumatic seal required for accurate water level sensing.
|
VIEW ON AMAZON
#CommissionsEarned
|
|
4%
CONF
|
Drain Pump Assembly
A physical leak from the drain pump housing or a failed internal seal can cause a genuine 'LE' condition. If the pump's impeller housing is cracked or the seal has been compromised by debris, the resulting loss of water will be detected by the pressure sensor, leading to a cycle abort and the inability to enter the spin phase.
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Water Level Pressure Sensor.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.