SAMSUNG WA45T3400AW Stops Mid Cycle
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Water Inlet Valve Assembly
The machine halts when the control board fails to detect a water level change within a specific timeframe during the rinse transition. This is typically caused by a dielectric failure in the solenoid coils, which prevents the valve from opening despite receiving a signal. Without the influx of water to trigger the pressure transducer, the logic controller enters a hard-stop state to protect the internal components.
SKU: DC62-00266G
|
VIEW ON AMAZON
#CommissionsEarned
|
|
8%
CONF
|
Drain Pump Motor Assembly
Mid-cycle stops often occur when the unit cannot evacuate the wash water to begin the spin phase. If the pump impeller is jammed or the motor windings have reached a thermal limit, the unit will remain in a 'wait' state. The pressure sensor continues to report a 'tub full' frequency, which prevents the high-speed centrifugal sequence from initiating.
SKU: DC97-17366A
|
VIEW ON AMAZON
#CommissionsEarned
|
|
6%
CONF
|
Water Level Pressure Sensor
This component uses a diaphragm and a magnetic core to convert air pressure into a frequency signal for the main PCB. If the diaphragm is ruptured or the air tube is obstructed, the sensor sends an 'out-of-range' signal. The system software interprets this as a critical sensor error and terminates the cycle mid-sequence for flood prevention.
SKU: DC96-01703G
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Water Inlet Valve Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.