ROBOROCK S5 MAX Error Code 9
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Washable HEPA Filter (OEM)
Error 9 is triggered when the internal Hall effect sensor fails to detect the magnet embedded in the filter frame. Aftermarket filters often omit this magnet to save costs, and OEM magnets can become dislodged during cleaning. Replacing the filter with a verified magnetic unit restores the detection circuit.
SKU: SDLW04RR
|
|
|
7%
CONF
|
Dust Bin Assembly
If the filter is present but the error persists, the plastic housing of the dustbin may be warped or the retention clips may be worn. This prevents the filter magnet from sitting within the narrow detection range of the chassis sensor, resulting in a persistent 'bin missing' signal.
|
|
|
2%
CONF
|
Internal Hall Effect Sensor Board
In rare cases of liquid ingress or vibration-induced solder fatigue, the Hall effect sensor located on the internal sub-PCB fails. This component is responsible for translating the magnetic flux into a logic signal for the motherboard; if it fails, the robot cannot clear the Error 9 lockout regardless of bin status.
|
DIY Repair Guide
Watch exactly how to replace the Washable HEPA Filter (OEM).
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.