ROBOROCK S5 MAX Sensor Clean
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
Cliff Sensor Assembly Harness
The S5 Max utilizes a series of four infrared cliff sensors wired in a serial harness. If any of the internal IR LEDs fail or if the phototransistors lose sensitivity due to component aging, the circuit will fail its continuity and signal check during startup, triggering the 'Sensor Clean' or 'Error 4' message. Replacing the entire harness ensures all sensor nodes are restored to factory voltage thresholds.
SKU: 9.01.0501
|
|
|
4%
CONF
|
Wall Sensor Module
The side-mounted wall sensor uses the same infrared triangulation principle as the cliff sensors. If the wall sensor's lens is internally scratched or the emitter fails, the robot cannot maintain a consistent distance from vertical surfaces, often resulting in a generic sensor error that persists after cleaning the exterior lens.
|
|
|
3%
CONF
|
Front Bumper IR Lens Window
The front bumper contains a dark polycarbonate window that filters out ambient light for the internal IR sensors. Over time, micro-scratches from furniture impacts cause light diffusion, which prevents the IR beam from focusing correctly. This diffusion mimics the signal attenuation caused by dust, leading the MCU to trigger a cleaning alert.
|
DIY Repair Guide
Watch exactly how to replace the Cliff Sensor Assembly Harness.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.