MAYTAG WASHER MHW5630HW Leaking From Bottom
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Drain Pump Assembly
This is the most common cause for water pooling directly under the center or front-right of the machine. Debris like coins or hairpins can damage the internal impeller seal, or the pump housing itself can develop a hairline crack, leading to a constant leak during the drain cycle.
SKU: W11419171
|
|
|
5%
CONF
|
Door Boot Bellows
If the leak appears at the front-bottom, it is likely a puncture or tear in the rubber gasket. Even a small pinhole in the bellows will allow water to escape during the wash cycle, which then tracks down the inside of the front panel and onto the floor.
|
|
|
4%
CONF
|
Water Inlet Valve
Search data indicates a pattern failure where excessive pressure or a faulty solenoid causes water to bypass the dispenser housing. This water overflows behind the detergent drawer and runs down the interior cabinet wall, eventually pooling at the bottom-left corner of the unit.
SKU: W11168748
|
DIY Repair Guide
Watch exactly how to replace the Drain Pump Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.