KITCHENAID KDTE204KPS Not Filling With Water
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Water Inlet Valve
The water inlet valve is an electromechanical solenoid that opens when energized. Over time, the internal diaphragm can become brittle or the solenoid coil can fail electrically, preventing the gate from opening to allow water into the tub. This is the most common failure point for 'no fill' symptoms in this chassis.
SKU: W11175771
|
|
|
6%
CONF
|
Overfill Protection Float Switch
The float switch acts as a safety interrupt. If the float becomes stuck in the 'up' position due to debris or if the microswitch fails internally, the control board assumes the dishwasher is already at maximum water capacity and will not trigger the fill valve to prevent a flood.
SKU: WPW10195707
|
|
|
3%
CONF
|
Electronic Control Board
The main control board houses the relays responsible for distributing line voltage to peripheral components. If the specific relay for the water inlet valve experiences contact pitting or solder joint failure, the board will fail to send the required signal to begin the fill sequence.
SKU: W11419071
|
DIY Repair Guide
Watch exactly how to replace the Water Inlet Valve.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.