KITCHENAID KDPE234GPS Error
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
Dishwasher Heating Element
The heating element is responsible for thermal gain during the wash and rinse cycles. If the resistive coil within the element fractures, the circuit opens and the water never reaches the target temperature. The control logic stays in a 'thermal hold' state to compensate, leading to excessively long run times and an eventual timeout error.
SKU: W10703867
|
VIEW ON AMAZON
#CommissionsEarned
|
|
4%
CONF
|
OWI Sensor (Optical Water Indicator)
This component contains the NTC thermistor used to monitor water temperature. If the thermistor's resistance-to-temperature curve shifts or the sensor lens is fouled by mineral deposits, the control board receives inaccurate data regarding the thermal state of the water, causing the cycle to run indefinitely as it waits for a temperature rise that has already occurred or cannot be detected.
|
VIEW ON AMAZON
#CommissionsEarned
|
|
3%
CONF
|
Electronic Control Board
The control board houses the heater relay and the logic processing for the OWI sensor. If the relay contacts are charred or the logic circuit fails to interpret the thermistor signals correctly, the board will not energize the heating circuit or will fail to advance the cycle timer, resulting in the reported symptoms.
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Dishwasher Heating Element.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.