KITCHENAID KDPE234GPS Water In Bottom
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Drain Pump
The drain pump utilizes a centrifugal impeller to evacuate water. Over time, the seal can fail, allowing moisture into the motor windings, or debris can jam the impeller. If the motor cannot reach the required RPM to overcome the height of the drain hose, water remains in the sump.
SKU: WPW10348269
|
VIEW ON AMAZON
#CommissionsEarned
|
|
5%
CONF
|
Drain Link Check Valve
This rubber flapper is located at the pump outlet and is designed to permit one-way flow. If the rubber stretches or becomes coated in fats/oils, it fails to seal when the pump stops, allowing the entire volume of water currently in the drain hose to flow back into the dishwasher tub via gravity.
|
VIEW ON AMAZON
#CommissionsEarned
|
|
4%
CONF
|
Drain Hose
Internal blockages caused by accumulated food particulate or 'schmutz' increase the backpressure on the pump. This reduces the flow rate to the point where the timed drain cycle ends before all water is evacuated, leaving standing water in the tub.
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Drain Pump.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.