KITCHENAID KDPE234GPS Not Filling With Water
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Water Inlet Valve
The water inlet valve is an electromagnetic solenoid that manages water flow into the basin. Failure occurs when the copper windings in the solenoid coil suffer an open-loop failure or when internal mineral deposits physically jam the plunger/diaphragm assembly. Without mechanical actuation of this valve, water cannot enter the machine despite electronic commands from the control board.
SKU: W11175771
|
VIEW ON AMAZON
#CommissionsEarned
|
|
5%
CONF
|
Overfill Protection Float Switch
This component acts as a safety flood-prevention interlock. If the physical float is stuck in the elevated position due to debris or if the microswitch has failed in the 'closed' position, the control logic perceives the tub as already full. This prevents the logic board from sending power to the fill valve to prevent a potential flood event.
SKU: WPW10195039
|
VIEW ON AMAZON
#CommissionsEarned
|
|
4%
CONF
|
Door Latch Assembly
The dishwasher cycle cannot advance to the fill stage unless the control board detects a completed circuit through the door latch switches. If the mechanical strike fails to fully depress the microswitch, or if the switch contacts have oxidized, the machine will remain in a standby state and fail to initiate the water intake sequence.
SKU: W11307244
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Water Inlet Valve.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.