KENMORE FRIDGE COLDSPOT 106 Not Cooling
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Compressor Start Relay and Overload Kit
On Kenmore 106 (Whirlpool-built) models, the PTC start relay contains a ceramic disc that frequently shatters or degrades over time. When this fails, the compressor cannot engage its start windings and will fail to run, often accompanied by a clicking sound every few minutes as the overload protector trips. This kit replaces the entire start device assembly to restore compressor operation.
SKU: 8201786
|
|
|
5%
CONF
|
Defrost Thermostat (Bimetal)
If the freezer is still cooling but the refrigerator section is warm, the defrost thermostat has likely failed to close during the defrost cycle. This causes ice to build up on the evaporator coils, eventually choking off the airflow to the refrigerator compartment. Replacing this sensor ensures the heater properly melts frost accumulation.
SKU: WPW10225581
|
|
|
4%
CONF
|
Adaptive Defrost Control (ADC) Board
The ADC board controls the timing of the cooling and defrost cycles. If the board's logic fails or a relay on the board sticks, the refrigerator may become 'stuck' in the defrost mode (where only the lights work but fans and compressor stay off) or fail to initiate defrosting entirely, leading to total cooling loss.
SKU: WPW10366605
|
DIY Repair Guide
Watch exactly how to replace the Compressor Start Relay and Overload Kit.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.