HILTI TE 60-ATC Atc No Hammering Action
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
92%
CONF
|
Seal and Lubricant Service Kit
The TE 60 uses a floating striker propelled by pneumatic pressure generated by a reciprocating piston. Over time, the OEM grease carbonizes or mixes with masonry dust, creating a high-viscosity sludge that causes the striker to adhere to the cylinder wall (stiction). Replacing the fluorinated O-rings and using the specific Hilti G-series grease restores the airtight seal and low-friction environment necessary for the pneumatic cycle to function.
|
|
|
8%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
DIY Repair Guide
Watch exactly how to replace the Seal and Lubricant Service Kit.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.