HILTI TE 60-ATC/AVR Atc Hammer Brush Reset
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
95%
CONF
|
Carbon Brush Set
The TE 60 features an electronic service module that monitors the physical length of the motor's carbon brushes. Once the brushes wear beyond the safety limit, the internal circuit is often physically interrupted by an auto-stop pin to prevent armature arcing, which triggers the 'Service' light and ATC lockouts. Replacing the brushes restores the electrical contact and resets the monitoring logic for the next duty cycle.
|
VIEW ON AMAZON
#CommissionsEarned
|
|
5%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Carbon Brush Set.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.