ECOVACS DEEBOT X2 OMNI Omni Lidar Navigation Lost
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
92%
CONF
|
Solid-State LiDAR Sensor Module
The Deebot X2 Omni utilizes a fixed solid-state LiDAR system rather than a traditional spinning turret. This module uses Time-of-Flight (ToF) laser pulses to map environments; a 'Navigation Lost' error signifies that the sensor is failing to emit or receive these pulses. Since the unit lacks a drive motor to fail, the root cause is typically an internal diode failure or a localized circuit fault within the sensor array itself.
|
|
|
8%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
DIY Repair Guide
Watch exactly how to replace the Solid-State LiDAR Sensor Module.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.