DYSON V11 Not Spinning
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
High Torque Cleaner Head Assembly
The internal DC motor or the Dynamic Load Sensor (DLS) PCB within the head has likely failed due to micro-dust ingress or a thermal fuse event. Since the internal motor and gearbox are sealed units, replacing the entire cleaner head assembly is the only reliable method to restore the electromechanical drive required to rotate the brush bar.
|
|
|
5%
CONF
|
Replacement Wand (Nickel/Blue/Gold)
The wand acts as the primary electrical conduit between the battery and the brush motor; internal wire fatigue or damaged contact pins at the 'click-in' points can interrupt the 25-30V DC circuit. If the main motor pulses but the head receives no power, the failure is often a break in the internal loom of the wand.
SKU: 970014-01
|
|
|
4%
CONF
|
Brush Bar (High Torque)
Mechanical seizure of the end-cap bearings or deformation of the plastic hexagonal drive socket can prevent the motor from engaging the bar. If the motor is spinning internally but the bar remains stationary, the physical interface between the drive cog and the roller has likely stripped or seized.
SKU: 970135-01
|
DIY Repair Guide
Watch exactly how to replace the High Torque Cleaner Head Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.