DYSON V11 OUTSIZE Outsize Clog Light Stuck On
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
92%
CONF
|
Dyson V11 Outsize HEPA Filter
The V11 Outsize filter uses a PTFE-based HEPA membrane that can become 'blinded' by ultra-fine particulates that are not visible to the eye. This creates a permanent high-resistance state across the intake, triggering the differential pressure sensor regardless of physical debris presence. Replacing the filter restores the nominal airflow required by the firmware to clear the blockage logic state.
SKU: 970422-01
|
VIEW ON AMAZON
#CommissionsEarned
|
|
8%
CONF
|
Main Body and Cyclone Assembly
If the blockage indicator persists with no filter installed, the internal pressure sensor port has likely become clogged with fine dust or damaged by moisture ingress. As the sensor is integrated into the digital motor control board within the housing, the entire main body must be replaced to restore correct airflow sensing.
SKU: 970424-01
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Dyson V11 Outsize HEPA Filter.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.