DUALTRON THUNDER 2 Error
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
85%
CONF
|
EY3 LCD Throttle Assembly
The EY3 unit houses the logic board that converts mechanical trigger movement into digital signals via a Hall effect sensor. A generic error typically signifies a failure in the UART communication bus or a sensor voltage out-of-range condition, often caused by internal PCB corrosion or mechanical displacement of the trigger magnet.
SKU: EY3-60V80V
|
|
|
10%
CONF
|
Main Controller (Motor Controller)
If the throttle assembly is functional, the logic gate on the motor controller's receiver end may have failed. This prevents the controller from interpreting the throttle's signal, though this is statistically less common than peripheral failure.
|
|
|
5%
CONF
|
6-Pin Communication Harness
Physical fatigue at the scooter's folding neck can lead to internal fractures in the copper wiring, specifically the data lines (TX/RX), which severs the connection between the display and the drive system.
|
DIY Repair Guide
Watch exactly how to replace the EY3 LCD Throttle Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.