WHIRLPOOL WRF555SDF Freezing Up Not Cooling
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
Defrost Bi-Metal Thermostat
This thermal switch is designed to close when the evaporator reaches a specific low temperature, allowing current to flow to the defrost heater. If the internal contacts fail or the casing becomes 'blown' (expanded), the defrost cycle will not initiate despite commands from the control board. Replacing this component restores the electrical path required to melt frost accumulation on the evaporator fins.
SKU: WPW10225581
|
VIEW ON AMAZON
#CommissionsEarned
|
|
4%
CONF
|
Defrost Heater Assembly
The defrost heater is a calrod-style heating element that physically melts frost off the evaporator coils. Over time, the resistive element inside the tube can burn out or develop a hairline fracture, resulting in an open circuit. Without radiant heat during the defrost cycle, the evaporator will eventually become a solid block of ice, occluding all airflow to the refrigerator.
SKU: WPW10300024
|
VIEW ON AMAZON
#CommissionsEarned
|
|
3%
CONF
|
Main Control Board
The main control board contains the logic and the physical relay that sends 120V to the defrost circuit. If the relay on the board fails or the logic timing is corrupted, the unit will never enter the defrost state. This is considered the 'brain' failure and is the primary cause if the thermostat and heater are found to be electrically continuous.
SKU: WPW10503278
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Defrost Bi-Metal Thermostat.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.