WHIRLPOOL WRF535SWHZ Ice Maker Not Filling With Water
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Water Inlet Valve
This component contains two separate solenoid coils. A failure in the specific coil dedicated to the ice maker prevents the electromagnetic plunger from lifting, which physically blocks water from entering the fill tube even if the control board sends the correct voltage. This is the primary failure point when water is available at the dispenser but not the ice mold.
SKU: WPW10420083
|
|
|
8%
CONF
|
Freezer Door Switch
This is a double-throw switch that serves as a safety interlock for the ice maker. If the internal contacts for the ice maker circuit fail or become high-resistance, the unit's control logic interprets the freezer door as being open, which electronically inhibits the water fill sequence to prevent potential splashing or ice jams.
|
|
|
6%
CONF
|
Ice Maker Assembly
The ice maker initiates the fill cycle via a mechanical timing cam or an internal mold thermostat. If the thermostat fails to detect the 'ready' temperature or the drive motor's gears are stripped, the sequence will stall before the fill command is triggered, resulting in a dry tray despite the rest of the water system being functional.
SKU: WPW10715708
|
DIY Repair Guide
Watch exactly how to replace the Water Inlet Valve.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.