WHIRLPOOL WRX735SDHZ Leaking Water
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Defrost Drain Hose Kit
The S-shaped drain hose design creates a natural collection point for sediment and ice, which eventually obstructs the drainage of condensate during the defrost cycle. When the path is blocked, the meltwater overflows the internal evaporator pan and migrates into the fresh food cabin or onto the floor. This updated part replaces the restrictive trap with a more efficient flow-through design to prevent recurring blockages.
SKU: W10619951
|
|
|
8%
CONF
|
Water Reservoir Tank Assembly
Located behind the crisper drawers, this plastic reservoir is subjected to continuous temperature cycling which leads to material fatigue and stress fracturing. If the leak is consistent and independent of the defrost cycle, the polymer housing has likely developed a hairline crack at the weld line or the inlet connection. This assembly is a sealed unit and must be replaced entirely if structural integrity is compromised.
|
|
|
6%
CONF
|
Water Inlet Valve
The solenoid-actuated valve controls water flow to the ice maker and dispenser; if the valve body cracks or the solenoid fails to seat properly due to mineral deposits, water will seep from the rear of the unit. This often results in a slow, steady leak that pools at the base of the refrigerator near the compressor compartment. Replacement of the valve assembly ensures the hydraulic seal is restored to factory specifications.
SKU: W10408179
|
DIY Repair Guide
Watch exactly how to replace the Defrost Drain Hose Kit.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.