WHIRLPOOL DUET Board Error
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
95%
CONF
|
Main Electronic Control Board
The F01 code indicates a checksum error or a failure in the communication between the micro-controller and the EEPROM. This usually stems from a hardware-level failure in the logic circuit or a stuck motor relay that prevents the board from passing its initial self-test. Replacing the main board restores the integrity of the control logic and high-voltage switching capabilities.
SKU: WPW10111606
|
|
|
5%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
DIY Repair Guide
Watch exactly how to replace the Main Electronic Control Board.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.