TESLA GEN 3 WALL CONNECTOR Charger Wifi Connectivity Setup Loop
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
92%
CONF
|
Main Control Board (PCBA)
The setup loop is triggered by a firmware incompatibility with modern WPA3 security protocols, leading to a synchronization failure during the handshake phase. This failure causes the internal microprocessor to crash and restart the commissioning broadcast repeatedly as the watchdog timer fails to see a successful network join. Replacing the logic board resets the system's firmware state, enabling the charger to bypass the corrupted provisioning cycle and successfully receive the required v26.2 update.
SKU: 1529455-00-D
|
VIEW ON AMAZON
#CommissionsEarned
|
|
8%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Main Control Board (PCBA).
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.