TESLA WALL CONNECTOR (GEN 3) Charger Handle Button Not Opening Port
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
92%
CONF
|
Wall Connector Cable Assembly
The charging handle contains an integrated RF transmitter and microswitch that broadcasts a signal to the vehicle's charge port. Mechanical fatigue of the internal switch or a fracture in the signal conductor within the cable prevents the 'open' command from being sent. Because the handle is a sealed, non-serviceable unit, the entire cable and handle assembly must be replaced to restore RF functionality.
SKU: 1118540-00-G
|
|
|
8%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
DIY Repair Guide
Watch exactly how to replace the Wall Connector Cable Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.