STIHL MS 362 Broken
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
96%
CONF
|
Chain Tensioner Kit
This kit contains the adjusting screw and the tensioner slide (pin). Failure typically occurs when the tensioning pin shears or the screw threads strip due to adjusting tension while the bar nuts are still tightened. This kit replaces the entire internal mechanical linkage responsible for bar movement.
SKU: 1125 007 1021
|
VIEW ON AMAZON
#CommissionsEarned
|
|
3%
CONF
|
Sprocket Cover
On the MS 362, the tensioner mechanism is housed within or adjacent to the sprocket cover. If the saw was dropped or operated with a loose bar, the casting that holds the tensioner screw in alignment can crack or warp, preventing the gears from meshing even if the screw itself is intact.
SKU: 1140 640 1700
|
VIEW ON AMAZON
#CommissionsEarned
|
|
1%
CONF
|
Guide Bar Studs
If the bar studs are bent or the threads are damaged, the guide bar cannot sit flush against the tensioner slide. This misalignment causes the tensioner pin to slip out of the guide bar hole or apply force at an angle, leading to the perception of a broken tensioner mechanism.
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Chain Tensioner Kit.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.