SPEED QUEEN TR7 LID Lock Flashing Error
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
85%
CONF
|
Lid Lock Assembly
The flashing light signifies that the electronic control board is attempting to engage the locking solenoid but is failing to receive a 'closed' confirmation from the internal microswitch. This is most often caused by a failed solenoid or high resistance in the switch contacts within the assembly. Replacing this part restores the required feedback loop to allow the cycle to proceed past the sensing phase.
|
VIEW ON AMAZON
#CommissionsEarned
|
|
15%
CONF
|
Lid Striker
If the plastic striker attached to the lid is chipped, bent, or misaligned, it will not properly depress the lock mechanism to allow the solenoid to engage. This mechanical interference results in the same flashing error as an electrical failure.
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Lid Lock Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.