SONY TV BRAVIA BLINKING RED LIGHT 6 TIMES General Troubleshooting
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
92%
CONF
|
LED Backlight Strip Replacement Kit
On Sony Bravia platforms, the 6-blink error code indicates a 'Backlight System' failure. This occurs when the main board or power supply (G-board) detects an over-current or under-current condition in the LED circuit, usually caused by a single failed LED diode on a strip. Replacing the entire array of strips ensures uniform current draw and prevents the protection circuit from shutting down the unit.
|
|
|
8%
CONF
|
Power Supply Board (G-Board / LED Driver)
If the backlight strips are functional, the secondary failure point is the LED driver circuit located on the power supply board. This board is responsible for stepping up voltage to drive the LED array; if the capacitors or inverter transistors fail, it will trigger the same 6-blink diagnostic code. This is the preferred replacement if the technician cannot safely disassemble the panel layers to reach the LEDs.
|
DIY Repair Guide
Watch exactly how to replace the LED Backlight Strip Replacement Kit.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.