SHARK SHARK IQ ROBOT RV1001 Bumper Stuck
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
88%
CONF
|
Bumper Sensor Board
The bumper sensor board contains the tactile microswitches that detect physical displacement of the bumper shroud. A 'stuck' error occurs when these switches experience mechanical failure or internal contact oxidation, causing them to remain in a 'closed' state even without an impact. Replacing the board ensures that the logic controller receives a correct 'normally open' signal when the bumper is in its neutral position.
|
|
|
12%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
DIY Repair Guide
Watch exactly how to replace the Bumper Sensor Board.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.