SEGWAY NINEBOT MAX G30P Error Code 14
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
95%
CONF
|
Thumb Throttle Assembly
The Error 14 code is explicitly defined by the manufacturer as a Throttle Hall Sensor abnormality. This failure occurs when the sensor fails to provide a valid linear voltage to the controller, often due to internal semiconductor degradation or magnet displacement. Replacing the throttle assembly restores the correct magnetic-to-electric signal conversion required for motor commutation.
SKU: 16.03.0001.00
|
|
|
5%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
DIY Repair Guide
Watch exactly how to replace the Thumb Throttle Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.