SAMSUNG WASHER WA45T3400 WON T FILL General Troubleshooting
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Water Inlet Valve Assembly
The inlet valve contains multiple solenoids that open the internal diaphragms to allow water flow. Over time, these solenoids can suffer from electrical continuity failure or the internal screens become clogged with sediment, preventing water from entering the tub despite receiving voltage from the main PCB.
SKU: DC97-15459H
|
|
|
8%
CONF
|
Water Level Pressure Sensor
This sensor measures the air pressure in a tube connected to the outer tub to determine the water level. If the internal diaphragm of the sensor fails or the sensor sends an incorrect frequency to the control board, the washer will 'think' it is already full and skip the fill portion of the cycle entirely.
SKU: DC96-01703G
|
|
|
6%
CONF
|
Lid Lock Latch Assembly
Samsung top-load firmware requires a confirmed 'Lid Closed' signal from the latch assembly before the control board authorizes the water inlet valves to open. A failure in the latch's internal switch or the solenoid that locks the lid will halt the cycle at the 'sensing' phase, preventing any water from entering.
SKU: DC34-00025A
|
DIY Repair Guide
Watch exactly how to replace the Water Inlet Valve Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.