SAMSUNG NX60A6511 Error Code F1
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
85%
CONF
|
Oven Control Board (Main PCB)
The F1 code is a diagnostic flag indicating a logic failure within the main processor, specifically a failure to read the temperature sensing circuit. This occurs when the EEPROM or ADC (Analog-to-Digital Converter) on the board degrades due to heat cycles or electrical transients. Replacing the board resets the control logic and restores proper sensor polling.
SKU: DE92-03960B
|
|
|
10%
CONF
|
Oven Temperature Sensor (RTD)
The F1 code can be triggered if the Resistance Temperature Detector (RTD) fails to provide a stable ohm reading within the microcontroller's expected range. Thermal expansion and contraction can cause the internal wire-wound element of the sensor to fracture, creating an open circuit condition that the control board interprets as a system failure.
SKU: DG32-00002B
|
|
|
5%
CONF
|
Wire Harness (Oven Sensor Connector)
Vibration and heat can cause the electrical connectors between the temperature sensor and the main PCB to loosen or oxidize. This increases resistance across the circuit, leading the control board to throw an F1 error due to signal noise or a perceived open-circuit state.
|
DIY Repair Guide
Watch exactly how to replace the Oven Control Board (Main PCB).
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.