SAMSUNG RANGE NE59J7850 BURNER Not Lighting
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Radiant Surface Element (Triple)
The heating ribbon inside the ceramic element housing often develops a 'hot spot' or fatigue break from repeated thermal expansion. If the ribbon is severed, the circuit remains open and the burner will not glow or produce heat. This specific part is for the large front-right triple-zone burner, which is the most frequently used and highest-failure component on this model.
|
|
|
9%
CONF
|
Main Electronic Control Board
This board contains the mechanical relays that switch 240V power to the surface elements. As noted in consumer reports regarding board failures on this series, carbon buildup or solder joint failure on the relay can prevent voltage from reaching the burner, even if the user interface appears to be working.
|
|
|
5%
CONF
|
Surface Element Control Switch
Also known as the infinite switch, this component regulates the duty cycle of the burner. Internal contact pitting or mechanical failure of the internal bimetal strip can prevent the switch from completing the circuit to the heating element.
|
DIY Repair Guide
Watch exactly how to replace the Radiant Surface Element (Triple).
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.