SAMSUNG FLEXWASH TOP WASHER Door Error
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Upper Washer Door Lock Switch
This switch monitors the closed state of the top washer. In Flexwash models, the 1dC4 error (Door Error) is most commonly caused by the failure of this electrical switch to signal the control board that the inner lid is secured, often due to internal contact corrosion or mechanical fatigue.
|
|
|
12%
CONF
|
Upper Washer Inner Lid Assembly
If the plastic latching tabs on the inner door assembly are chipped or warped, the door will not physically engage the safety switch. Because the switch is often integrated or requires specific alignment with the lid's geometry, replacing the full inner door assembly is frequently required to ensure a proper mechanical fit.
|
|
|
2%
CONF
|
Main Control Board (PCB)
The control board processes the 'closed' signal from both the top and bottom door switches. If the switches and wiring harnesses test positive for continuity but the error persists, the logic gate on the PCB responsible for door state monitoring has likely failed.
|
DIY Repair Guide
Watch exactly how to replace the Upper Washer Door Lock Switch.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.