IROBOT BRAAVA JET M6 Error 15 Lid Open
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
92%
CONF
|
Top Lid Assembly
The Braava Jet M6 features a top-loading lid for water tank access that relies on plastic retention tabs (tenons) to stay closed. These tabs are subject to mechanical fatigue and stress-cracking from the robot's impact with baseboards, eventually losing the ability to hold the lid flush against the Hall effect sensor. Replacing the lid assembly restores the magnetic proximity required for the sensor to signal a 'closed' state to the logic board.
|
|
|
8%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
DIY Repair Guide
Watch exactly how to replace the Top Lid Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.