ROBOROCK S8 MAXV ULTRA Not Washing
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Clean Water Tank Assembly
The clean water tank contains the primary spring-loaded check valve and filtration screen. Failure of the internal seal or mineral accumulation in the mesh screen prevents the dock's pump from drawing water, leading to a 'Not Washing' state even with a full tank.
|
|
|
4%
CONF
|
Mop Cleaning Brush Motor Assembly
If water is present but the mop is not being agitated, the drive motor for the high-speed cleaning brush has likely seized. This prevents the mechanical scrubbing action necessary for the 'washing' cycle to complete successfully.
|
|
|
5%
CONF
|
Dock Water Filter Strainer
This fine mesh strainer sits at the base of the dock where the tank connects. It is prone to bio-film buildup which creates high fluid resistance, causing the system to trigger a dry-run error and stop the washing process.
|
DIY Repair Guide
Watch exactly how to replace the Clean Water Tank Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.