RAD POWER BIKES RADROVER 6 PLUS Power Radrover 6 Error Code 25
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Hydraulic Brake Lever Assembly with Integrated Cutoff Switch
The RadRover 6 Plus utilizes hydraulic brakes with an integrated electronic inhibitor switch. Error 25 signifies that the controller detects the brake switch is closed during startup. This is most commonly caused by a mechanical failure in the lever's return stroke or a localized electrical short in the integrated sensor, which permanently signals the 'braking' state to the controller.
|
|
|
7%
CONF
|
Brake Sensor Wiring Harness (Inline Connector)
Environmental contamination or physical damage to the wiring pins at the harness junction can cause a short circuit. If the signal wire is grounded due to water ingress or a pinched cable, the controller interprets this as an active brake pull, triggering the safety lockout code.
|
|
|
2%
CONF
|
36V/48V Motor Controller
If the brake levers and wiring are verified as functional, the failure logic likely resides in the motor controller's input processing circuit. A blown transistor or logic gate on the controller board can cause a false positive reading of the brake inhibitor circuit, requiring a full replacement of the sealed controller unit.
|
DIY Repair Guide
Watch exactly how to replace the Hydraulic Brake Lever Assembly with Integrated Cutoff Switch.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.