PIT BOSS PRO SERIES 1150 Error
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
95%
CONF
|
RTD Temperature Probe Sensor
The Er1 code is the firmware's response to a detected open circuit in the temperature sensing loop. This occurs when the RTD probe's internal filament fails or the lead wires become disconnected, preventing the PID controller from receiving the resistance data required for thermal regulation. Replacing the probe restores the essential feedback loop to the control board.
SKU: 70133
|
VIEW ON AMAZON
#CommissionsEarned
|
|
5%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the RTD Temperature Probe Sensor.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.