MIELE G-SERIES DISHWASHER Waterproof System Fault F70
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Sump Profile Gasket
This large-diameter elastomer seal sits between the stainless steel tub and the plastic sump assembly. Over time, thermal cycling and detergent exposure cause the rubber to lose elasticity and compress, allowing water to weep into the base tray during the wash cycle, which eventually triggers the F70 float switch.
|
|
|
8%
CONF
|
Overflow Float Switch
The microswitch itself can fail due to internal corrosion from high humidity in the base area or mechanical sticking. If the switch remains in the 'actuated' state even after water is removed, the control board will persistently display the F70 code and prevent operation.
|
|
|
6%
CONF
|
Circulation Pump Seal Kit
On older units, the radial shaft seal of the main circulation pump can degrade. This allows water to leak along the motor shaft and drip directly into the base tray during high-pressure wash phases, satisfying the buoyancy requirement for an F70 event.
|
DIY Repair Guide
Watch exactly how to replace the Sump Profile Gasket.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.