MAYTAG WASHER MVW7230HW NOT DRAINING Repair
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
39%
CONF
|
Wiring Harness
The absence of any pump noise strongly indicates a lack of electrical power reaching the drain pump. The wiring harness leading to the drain pump is a common failure point in Maytag washers, often experiencing breaks or fraying that interrupt power, directly causing the pump to not operate and resulting in the 'LD' error and F32 code.
SKU: W11458657
|
|
|
33%
CONF
|
Drain Pump
Even though the drain pump's resistance (16.4 ohms) is within the normal operating range, the motor itself can be internally seized or have a mechanical failure that prevents the impeller from turning and producing any sound, even if power is supplied. This internal failure would prevent water drainage and trigger the 'LD' error and F32 code.
|
|
|
28%
CONF
|
Obstruction in Drain Pump
Debris such as coins, lint, or small articles of clothing can jam the drain pump impeller, preventing it from spinning. While a severe obstruction might cause a humming sound as the motor attempts to operate, a complete blockage could prevent any audible operation, leading to the 'LD' error and F32 code due to the inability to drain.
|
DIY Repair Guide
Watch exactly how to replace the Wiring Harness.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.