KOHLER TOUCHLESS FLUSH TOILET KIT (K-1954 / SAN SOUCI) General Troubleshooting
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
Battery Holder Assembly and Cover Upgrade Kit
Manufacturer-identified design flaw where the original housing lacked adequate moisture shielding. This upgraded assembly prevents condensation from infiltrating the battery contact points and electronic control module, which previously caused 'phantom' shorting and erroneous flush triggers.
|
|
|
4%
CONF
|
Refill Hose / Tube Clip
Improperly seated refill hoses cause water to splash against the tank lid during the fill cycle. The resulting turbulent surface or lid droplets reflect the sensor's signal back to the receiver, leading the module to interpret the splash as a hand actuation.
|
|
|
3%
CONF
|
Flush Valve Seal / Flapper
Standard mechanical degradation of the seal allows water to leak from the tank into the bowl. While this is 'phantom running' rather than 'random flushing,' users often conflate the two; however, a significant drop in water level may also trigger fill-valve turbulence that disturbs the touchless sensor module.
SKU: GP1059291
|
DIY Repair Guide
Watch exactly how to replace the Battery Holder Assembly and Cover Upgrade Kit.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.