KENMORE ELITE 795 SERIES Leaking Water
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Water Inlet Valve Assembly
The water inlet valve utilizes electromagnetic solenoids to manage flow to the ice maker and dispenser. Over time, the internal diaphragm or the plastic valve body can develop hairline fractures or fail to seal completely under line pressure. This results in a slow, persistent leak that typically manifests at the rear base of the appliance.
SKU: AJU72902603
|
|
|
7%
CONF
|
Water Filter Head and Case Assembly
The filter head contains a bypass mechanism and O-ring seals that are subject to significant mechanical stress during filter replacement and water hammer effects. If the internal plastic manifold develops a stress crack or the seals degrade, water will leak from the filter compartment and track down the back of the interior liner. Replacing the entire head assembly restores the hydraulic integrity of the filtration interface.
SKU: ADQ36996101
|
|
|
7%
CONF
|
Drain Tube Assembly
During the defrost cycle, melted frost must exit the evaporator tray through a dedicated drain tube to the condensate pan. If this tube becomes obstructed by debris or ice due to a failed heat-trap design, the water overflows the internal trough and leaks into the refrigerator cabin or onto the floor. This part replaces the check valve and tube to ensure unobstructed gravity drainage.
SKU: 5251JA3003G
|
DIY Repair Guide
Watch exactly how to replace the Water Inlet Valve Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.