KENMORE ELITE 795 SERIES Error Code 22E
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
Evaporator Fan Motor
The 22E code indicates a feedback loop failure where the Main PCB is not receiving an RPM signal from the fan motor. This usually results from moisture entering the motor housing, causing the Hall effect sensor to short or the bearings to seize. Replacing the motor restores the necessary tachometer signal to the control board, allowing the cooling cycle to resume.
SKU: EAU61505013
|
|
|
6%
CONF
|
Ice Room Fan Motor Assembly
On many 795-series models, 22E specifically points to the fan responsible for circulating air into the door-mounted ice compartment. If this motor fails due to ice accumulation or electrical open-loop conditions, the system enters a fault state. This assembly includes the motor and housing required to restore airflow to the icemaker.
SKU: ABA72913411
|
|
|
1%
CONF
|
Main Power Control Board
While less common, the 22E error can be triggered if the DC voltage output or the signal processing circuit on the main PCB is damaged. If a new fan motor does not resolve the code, the logic board is failing to interpret the incoming pulses from the fan's tachometer circuit.
SKU: EBR73093901
|
DIY Repair Guide
Watch exactly how to replace the Evaporator Fan Motor.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.