KENMORE ELITE 41072 Error No Water
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
92%
CONF
|
Water Inlet Valve Assembly
The water inlet valve utilizes electromagnetic solenoids to actuate internal rubber diaphragms. Over time, the solenoid coils can develop an open circuit due to thermal fatigue, or mineral deposits can seize the plunger mechanism. This prevents the flow of water into the tub, causing the pressure switch to remain in the 'empty' state and triggering the IE timeout code.
SKU: AJU73213301
|
|
|
5%
CONF
|
Water Level Pressure Switch
This component acts as a frequency-based transducer that communicates the water level to the control board. If the internal diaphragm or the electronic circuit within the switch fails to register a change in air pressure from the rising water column, the machine will report an Inlet Error even if water is physically present.
SKU: EBF61315802
|
|
|
3%
CONF
|
Inlet Valve Filter Screens
Fine mesh screens located at the junction of the supply hoses and the inlet valve can become occluded with calcium carbonate or sediment. This restricts the volumetric flow rate to a level where the machine cannot reach its target water volume within the safety timeout period.
|
DIY Repair Guide
Watch exactly how to replace the Water Inlet Valve Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.