KENMORE KENMORE ELITE (795 SERIES) Error Code
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
92%
CONF
|
Ice Room Fan Motor
The icing fan motor provides the necessary airflow to the door-mounted ice maker; when the internal Hall effect sensor fails or the motor windings open, the control board loses the feedback loop. This specific component is the most frequent point of failure due to its operation in a high-humidity, sub-zero environment which promotes internal bearing corrosion. Replacing the motor restores the pulse-width modulation feedback signal to the main controller.
|
|
|
8%
CONF
|
Main Power Control Board
In rare instances, the logic gate on the control board responsible for interpreting the fan's RPM signal may fail despite a functional motor. This prevents the processor from acknowledging the fan's operation, maintaining the error state. This is considered a secondary failure mode if a known-good fan does not clear the diagnostic code.
SKU: EBR73348008
|
DIY Repair Guide
Watch exactly how to replace the Ice Room Fan Motor.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.