IROBOT ROOMBA I7+ (WITH CLEAN BASE) Clogged Light
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Clean Base Dirt Disposal Bags
The Clean Base utilizes a vacuum pressure sensor to monitor evacuation efficiency. Fine particulates like drywall dust or flour can occlude the microscopic pores of the bag's non-woven filter material without physically filling the bag's volume, causing a 'clog' alert due to the resulting drop in static pressure during the suction cycle.
SKU: 4640235
|
|
|
5%
CONF
|
Roomba i-Series High-Efficiency Filter
Airflow for the evacuation process must pass through the robot's internal filter. If the pleated media is saturated with fine debris, it creates a bottleneck that prevents the Clean Base from pulling sufficient air through the bin, triggering the tower's airflow obstruction sensor.
|
|
|
4%
CONF
|
Roomba i7 Washable Dust Bin
The i7 utilizes infrared (IR) beam sensors to detect bin capacity. If the translucent plastic windows on the bin become heavily scratched or coated in a static-bonded dust film, the IR signal is scattered or blocked, leading the firmware to report a persistent clog or full-bin error regardless of the actual debris level.
SKU: 4639334
|
DIY Repair Guide
Watch exactly how to replace the Clean Base Dirt Disposal Bags.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.